[ABANDONED] J-Link programmig error with Atmel SAMHA1 (Cortex-M0)

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] J-Link programmig error with Atmel SAMHA1 (Cortex-M0)

    When I using the J-Link Base to program the SMAHA1G16A, it will prompt the error dialog. The target board are use normally before, it happen suddenly. Please advise how to solve?
    Images

    • dialog.png

      37.03 kB, 759×599, viewed 297 times

  • Hello,

    Thank you for your inquiry.
    Such an issue is not known to us.
    Are you using custom hardware or an eval board?
    Which J-Link software version are you currently using? Does using the latest software version change the behaviour?
    Could you provide a J-Link log file of the failed session? wiki.segger.com/Enable_J-Link_log_file
    You seem to be using Atmel studio for programming.
    Could you alternatively try using either J-Link Commander to program your application or Ozone? segger.com/products/development-tools/ozone-j-link-debugger/


    Best regards,

    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.