I'm trying to get tracing working in Segger Embedded Studio.
Steps I've roughly followed:
* Create & configure a project for "externally built executable"
* Run "Target->Attach Debugger"
* Break/continue, etc.
The Execution Profile window is showing information, but Execution Trace says No trace data.
Is there an equivalent of the Ozone "Debug.ReadIntoTraceCache" function in Segger Embedded Studio?
Thanks,
Patrick
Steps I've roughly followed:
* Create & configure a project for "externally built executable"
* Run "Target->Attach Debugger"
* Break/continue, etc.
The Execution Profile window is showing information, but Execution Trace says No trace data.
Is there an equivalent of the Ozone "Debug.ReadIntoTraceCache" function in Segger Embedded Studio?
Thanks,
Patrick