[SOLVED] Segger ATE main board not recognizing modules

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hello,

    are the module's PWR LEDs lit?

    If they are not, most likely the output voltage of your power supply is not stable enough or not in the allowed range of 4.8V to 5.25V.

    The web server will show information about the power status on "Flasher ATE status".

    Best regards
    Arne
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • The power requirements for now are 4.8V to 5.25V. The power supply needs to keep the supply
    voltage in this range, otherwise the modules will automatically be powered down.

    We will change the requirements to 4.4V to 5.25V for the next firmware release.

    Do you have a better power supply available for now?

    Best regards
    Arne
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.