Dear Segger,
I am using Jlink Plus to hot-plug/attach to my running target (SAMD21) which works basically fine. This great.
Now I encounted problems when the firmware is longer in power-down.
I do not have checked the edge timing when is still works, I have an firmware with realizes two power-down timings and can reproduce the issue. When the mcu wakes every 10ms hot-attach works, when doing the wakes only every 2.5 s it fails. Then the reset line is asserted automatically by Jlink. I am using Ozone for testing. Seem that there is a timeout which leads to the hw reset. How to changes this behaviour?
regards
Stefan
I am using Jlink Plus to hot-plug/attach to my running target (SAMD21) which works basically fine. This great.
Now I encounted problems when the firmware is longer in power-down.
I do not have checked the edge timing when is still works, I have an firmware with realizes two power-down timings and can reproduce the issue. When the mcu wakes every 10ms hot-attach works, when doing the wakes only every 2.5 s it fails. Then the reset line is asserted automatically by Jlink. I am using Ozone for testing. Seem that there is a timeout which leads to the hw reset. How to changes this behaviour?
regards
Stefan