HI,
I have bought
I fail to download the firmware into the demo.
I got the error message "Failed to CPU Status after 4 retries"
Then, I run the J-Link STR9 Commander R6. In this program, I got error message
"Reset pin is high but should be low.
Please ensure that jumper RST-TRST is not set"
Please guide me how to proceed.
Thanks.
Br,
KonSang
I have bought
- SAMA5D3 Xplained Board.
- Segger J-Link
- IAR work bench trial.
I fail to download the firmware into the demo.
I got the error message "Failed to CPU Status after 4 retries"
Then, I run the J-Link STR9 Commander R6. In this program, I got error message
"Reset pin is high but should be low.
Please ensure that jumper RST-TRST is not set"
Please guide me how to proceed.
Thanks.
Br,
KonSang