I have a Nordic PCA10040 (dev kit for the NRF53832) which has an integrated J-LINK. When I connect to the PC there is also a JLINK CDC UART Port. It appears that the device has enumerated correctly.
When I try to connect to the port via putty I get an error that I cannot connect (picture attached).
I was able to connect to this board via Segger Embedded Studio, load code, debug, etc.
I have also tried to connect to the com port via a Python Script provide by nordic which give as "permission denied" error when I attempt to connect.
I tried:
Testarting the machine
Cycling the USB cable
Reinstalling the CDC driver.
Any ideas of how to fix the problem?
When I try to connect to the port via putty I get an error that I cannot connect (picture attached).
I was able to connect to this board via Segger Embedded Studio, load code, debug, etc.
I have also tried to connect to the com port via a Python Script provide by nordic which give as "permission denied" error when I attempt to connect.
I tried:
Testarting the machine
Cycling the USB cable
Reinstalling the CDC driver.
Any ideas of how to fix the problem?