Hello,
I'm having issues flashing a PSoC 5 LP device using J-Link. If I flash the same .hex using PSoC Programmer and Cypress own MiniProg it works.
If I use PSoC Programmer and MiniProg to read out the memory, I can see that the only difference in the two cases is that when flashing with MiniProg 'Config Flash Area' address 0x0400 contains some data (roughly between 0x0400 and 0x0f80).
- Anyone knows what this data is?
- How can I flash it using J-Link?
- Has anyone else successfully flashed a PSoC 5 LP device using J-Link?
Thanks, Jacob
I'm having issues flashing a PSoC 5 LP device using J-Link. If I flash the same .hex using PSoC Programmer and Cypress own MiniProg it works.
If I use PSoC Programmer and MiniProg to read out the memory, I can see that the only difference in the two cases is that when flashing with MiniProg 'Config Flash Area' address 0x0400 contains some data (roughly between 0x0400 and 0x0f80).
- Anyone knows what this data is?
- How can I flash it using J-Link?
- Has anyone else successfully flashed a PSoC 5 LP device using J-Link?
Thanks, Jacob