j-Link VCOM flow control blocks

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • j-Link VCOM flow control blocks

      Hi

      We are using the Nordic Semiconductor developer boards (nRF52 DK) with onboard j-Link often in our project. In the last months we observed multiple times that the serial communication over the VCOM on this j-Link is blocked somehow. Only a reset could release this blocking state. We tried a lot to find a solution to force the j-Link VCOM to reset the hardware flow control, but nothing could fix this behavior so far.

      Today I've found this abondoned thread (Link) in your forum, that could exactly describe our problem. Is there any news on this? When can we expect this to be fixed?

      Regards
      Adrian