j-Link VCOM flow control blocks

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • j-Link VCOM flow control blocks

    Hi

    We are using the Nordic Semiconductor developer boards (nRF52 DK) with onboard j-Link often in our project. In the last months we observed multiple times that the serial communication over the VCOM on this j-Link is blocked somehow. Only a reset could release this blocking state. We tried a lot to find a solution to force the j-Link VCOM to reset the hardware flow control, but nothing could fix this behavior so far.

    Today I've found this abondoned thread (Link) in your forum, that could exactly describe our problem. Is there any news on this? When can we expect this to be fixed?

    Regards
    Adrian
  • Hi Adrian,

    Unfortunately, we were not able to investigate this behavior yet due to some other pressing projects / tasks.
    We will update both threads as soon as we have any news regarding this.

    Best regards
    Erik
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.