Hello,
I am having problems to connect with J-trace programmer and programming an ARM-M3 cortex device (ATSAM3S2A) from ATMEL.
As a consequence of this, I cannot program the device through SWD interface.
When I try to connect I get some error messages as follows (I attach you the pop-up message):
Could not find core in Coresight setup
Could not perform custom init sequence
Could not halt CPU
I have been trying to understand that, but I could not fix it yet. The fact is that for an ARM-M3 cortex device ATSAM3S1A it works properly but not for ATSAM3S2A.
It is due to a lack of ROM file that needs to be loaded in J-Trace SW? I have also been looking at the wiki.segger.com web but I didn't find anything yet.
Does anybody know what is going wrong here?
Thank you in advance.
Regards
I am having problems to connect with J-trace programmer and programming an ARM-M3 cortex device (ATSAM3S2A) from ATMEL.
As a consequence of this, I cannot program the device through SWD interface.
When I try to connect I get some error messages as follows (I attach you the pop-up message):
Could not find core in Coresight setup
Could not perform custom init sequence
Could not halt CPU
I have been trying to understand that, but I could not fix it yet. The fact is that for an ARM-M3 cortex device ATSAM3S1A it works properly but not for ATSAM3S2A.
It is due to a lack of ROM file that needs to be loaded in J-Trace SW? I have also been looking at the wiki.segger.com web but I didn't find anything yet.
Does anybody know what is going wrong here?
Thank you in advance.
Regards