[ABANDONED] Getting error: Writing target memory failed

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hello,

    Thank you for your inquiry.
    What is the serial number of your J-Link?
    Which target device are you trying to program?
    Is it on an eval board or custom hardware?
    Can you post a screenshot of your full connect sequence?
    wiki.segger.com/J-Link_cannot_…ty_using_J-Link_Commander

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hello,

    Thank you for providing the connect sequence.
    To be able to pinpoint the cause of the issue, could you provide a photo of the J-Link you are using and how it is connected to your board?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.