I Have imx283 Board.
I am trying to connect using J-Link Plus but it is giving erroe as show below Log:
Application log started
- J-Flash V6.16g (J-Flash compiled Jul 10 2017 16:40:31)
- JLinkARM.dll V6.16g (DLL compiled Jul 10 2017 16:40:10)
Creating new project ...
- New project created successfully
Connecting ...
- Connecting via USB to J-Link device 0
- Target interface speed: 1000 kHz (Fixed)
- VTarget = 3.385V
- Executing init sequence ...
- Initialized successfully
- Target interface speed: 1000 kHz (Fixed)
- J-Link found 1 JTAG device. Core ID: 0x079264F3 (None)
- Connected successfully
Reading entire flash chip ...
- 1 sector, 1 range, 0x0 - 0xFFFFFFFF
- Start of determining flash info (Bank 0 @ 0x00000000)
- ERROR: Could not find CFI compliant flash device
- Error while determining flash info (Bank 0 @ 0x00000000)
- End of determining flash info
- Flash bank info:
- 1 * 0 bytes @ 0x00000000
- ERROR: Failed to read back target memory
I am trying to connect using J-Link Plus but it is giving erroe as show below Log:
Application log started
- J-Flash V6.16g (J-Flash compiled Jul 10 2017 16:40:31)
- JLinkARM.dll V6.16g (DLL compiled Jul 10 2017 16:40:10)
Creating new project ...
- New project created successfully
Connecting ...
- Connecting via USB to J-Link device 0
- Target interface speed: 1000 kHz (Fixed)
- VTarget = 3.385V
- Executing init sequence ...
- Initialized successfully
- Target interface speed: 1000 kHz (Fixed)
- J-Link found 1 JTAG device. Core ID: 0x079264F3 (None)
- Connected successfully
Reading entire flash chip ...
- 1 sector, 1 range, 0x0 - 0xFFFFFFFF
- Start of determining flash info (Bank 0 @ 0x00000000)
- ERROR: Could not find CFI compliant flash device
- Error while determining flash info (Bank 0 @ 0x00000000)
- End of determining flash info
- Flash bank info:
- 1 * 0 bytes @ 0x00000000
- ERROR: Failed to read back target memory