[ABANDONED] ERROR: Could not find CFI compliant flash device

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] ERROR: Could not find CFI compliant flash device

    I Have imx283 Board.

    I am trying to connect using J-Link Plus but it is giving erroe as show below Log:

    Application log started
    - J-Flash V6.16g (J-Flash compiled Jul 10 2017 16:40:31)
    - JLinkARM.dll V6.16g (DLL compiled Jul 10 2017 16:40:10)
    Creating new project ...
    - New project created successfully
    Connecting ...
    - Connecting via USB to J-Link device 0
    - Target interface speed: 1000 kHz (Fixed)
    - VTarget = 3.385V
    - Executing init sequence ...
    - Initialized successfully
    - Target interface speed: 1000 kHz (Fixed)
    - J-Link found 1 JTAG device. Core ID: 0x079264F3 (None)
    - Connected successfully
    Reading entire flash chip ...
    - 1 sector, 1 range, 0x0 - 0xFFFFFFFF
    - Start of determining flash info (Bank 0 @ 0x00000000)
    - ERROR: Could not find CFI compliant flash device
    - Error while determining flash info (Bank 0 @ 0x00000000)
    - End of determining flash info
    - Flash bank info:
    - 1 * 0 bytes @ 0x00000000
    - ERROR: Failed to read back target memory
    Images
    • j-link flash.png

      150.19 kB, 1,600×900, viewed 210 times
  • Hello,

    Thank you for your inquiry.
    Which board are you trying to program?
    Is it an eval board or custom hardware?
    Which external Flash are you trying to program?
    For the iMX2 series external Flash download is not supported by default.
    J-Flash can currently only program a CFI compliant external Flash that has been configured by the user.
    More information about this can be found in the J-Link user manual in section "Setup for various debuggers (CFI flash)".

    If you are looking for a custom Flash loader for your setup our open Flash loader interface can be used: wiki.segger.com/Adding_Support_for_New_Devices

    Best regards,
    Nino
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support contact us per e-mail.
    Alternatively our support ticketing system can be used as well: segger.com/ticket/