[Ozone]Problem debugging nRF52832

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • [Ozone]Problem debugging nRF52832

      Hi Nino,

      I would like to notice you that in the last Ozone released (2.56d), we have found an issue that avoid to debug our project.
      If you dont mind, I would like to send you our code in order to help us, to figure out what happens inside Ozone during this “crash”
      This problem is not reproducible in other versions of Ozone.

      Could you send me an email/message/link, where I can share my code with you in order to fix this issue?

      Kind regards,

      Paco
    • Hello Paco,

      Sorry for the delay in response.
      Does the issue persist with the latest Ozone versions as well?
      In the 2.56x versions we had a generic change that might affect devices like nRF52 that have a softdevice programmed.
      It should be working with the latest version again however.

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support contact us per e-mail.
      The following contact form can be used for this: segger.com/about-us/contact-us/

    • Hello Paco,

      Did you create a new project with the new version?
      What is the S/N of the J-Link you are using?

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support contact us per e-mail.
      The following contact form can be used for this: segger.com/about-us/contact-us/

    • New

      Hello Nino,
      We have a "JLink ultra+"(I prefer to provide you S/N in a mp) and a "JLink EDU" for workshops inside the company.
      I dont want to create a new project (It works), the problem is our main project has not been supported SWO interface from Ozone2.56d (from here on out), same code with different behaviour depending on Ozone version tested.
      Do you think it would be better to contact support directly?

      Thanks.
      Paco,