How can I hide information dialog while programming my card.
Actually would prefer shows details in ms command windows.
See attached image.
Details are as follows.
I am programming my RHOS card via JLINK exe in windows 10
with .bat file:
@SET CPU=MKE04Z128XXX4
@SET SW_TOOL="C:\Program Files (x86)\SEGGER\JLink_V622b\JLink.exe"
@SET COMMAND_FILE ="JunoCommandFile.jlink"
%SW_TOOL% -device %CPU% -if SWD -speed 4000 -jtagconf -1,-1 -autoconnect 1 -CommanderScript "JunoCommandFile.jlink"
and with JunoCommandFile.jlink file:
si 1
erase
loadfile "juno_main_software.srec"
loadfile "juno_par_software.srec"
q
Actually would prefer shows details in ms command windows.
See attached image.
Details are as follows.
I am programming my RHOS card via JLINK exe in windows 10
with .bat file:
@SET CPU=MKE04Z128XXX4
@SET SW_TOOL="C:\Program Files (x86)\SEGGER\JLink_V622b\JLink.exe"
@SET COMMAND_FILE ="JunoCommandFile.jlink"
%SW_TOOL% -device %CPU% -if SWD -speed 4000 -jtagconf -1,-1 -autoconnect 1 -CommanderScript "JunoCommandFile.jlink"
and with JunoCommandFile.jlink file:
si 1
erase
loadfile "juno_main_software.srec"
loadfile "juno_par_software.srec"
q
The post was edited 2 times, last by moguzalp ().