Hi,

in J-Scope I'm missing the feature that the manually set layout of the traces is saved in the config file, too.
At start, Y Resolution and Offset is scaled automatically according to the data, which generally helps, but I'd like to store my manual settings for the Y Res. and Offset, too. E.g. if something crashes I have to manually restore the settings every time.
Is there a way to make this easier?
Thanks!

Yes, I tested 5.10d and 6.11j.
YOffset="..." and YResolution="..." are stored and initially restored on opening an exisiting project, as you wrote. But the problem is that the channels get autoscaled and Y-shifted again when I start sampling and my manual settings are not respected any more.
I manually set the parameter IsAutoConfig="0" for all channels in the config file, but this does not help.
Maybe the question has to be rephrased: Is it possible to turn off autoscaling?

Hi, thanks for your reply. I retested and attached the files:

Setup: Win7Prof in Virtualbox on Fedora host, J-Link Edu, no issues with J-Scope or debugging
Steps done:
1) Created new project in J-Scope 6.11j.
2) Started sampling, Y resolution and offset was adjusted automatically.
3) Set Y resolution and Y offset, both for every channel, in the GUI, saved config to Test_01.jscope. (renamed later to Test_01.jscope.txt for upload)
4) Closed J-Scope.
5) Started J-Scope and loaded Test_01.jscope. The Y settings are as I set them manually before, see Test_01_opened.png.
6) Started sampling, target is generating data.
7) As soon as data comes in, J-Scope autoscales, see Test_01_StartedSampling.png
It does not matter if first sampling in J-Scope is started and then the target starts sending data or vice versa, the behaviour is the same.

Thanks for the info and the feature request!