Trying to use stand-alone mode. Flasher ARM hw version 4, s/n 164104208. Firmware compiled 2/12/2015 (distributed with J-Flash 5.10d). Running on Win7-32 PC.
Following instruction in users guide:
using J-Flash to save data & config to Flasher;
enter MSD mode to create _SECURE folder & move everything into it;
exit MSD mode;
connect via serial;
enter #AUTO.
Seeing $BTL log on serial console. "Trying to open firmware file... ERR: File not found."
Does not appear to enter stand-alone mode.
Used J-Link to issue "securearea remove" and "securearea create" but always get -262.
This used to work.
Tried going through Segger support, but Alex Gruner insists I cannot be having a problem.
Following instruction in users guide:
using J-Flash to save data & config to Flasher;
enter MSD mode to create _SECURE folder & move everything into it;
exit MSD mode;
connect via serial;
enter #AUTO.
Seeing $BTL log on serial console. "Trying to open firmware file... ERR: File not found."
Does not appear to enter stand-alone mode.
Used J-Link to issue "securearea remove" and "securearea create" but always get -262.
This used to work.
Tried going through Segger support, but Alex Gruner insists I cannot be having a problem.