[ABANDONED] How to disassemble cross-compiled ELF in ozone?

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] How to disassemble cross-compiled ELF in ozone?

    Hello, I was looking for a better side-by-side (C-and-assembly) view of the code than what gdb give you, so I am trying out ozone (other people apparently got it to work as you can see here). But after loading up my u-boot ELF file, ozone does NOT show me the assembly (only the machine code) as you can see in the attached picture.

    I would guess this is because ozone doesn't know where my cross-tool chain is--even though I have an environment variable called CROSS_COMPILE. How can I tell Ozone to use this toolchain (I would guess it has to call the right readelf and objdump)?

    Thanks for reading.
    • OzoneDisassemble.png

      14.67 kB, 430×98, viewed 95 times
  • Hello Henry,

    Thank you for your inquiry.
    Such behaviour is not known to us.
    What target device are you trying to debug?
    Does it happen during debug session too or is it shown then correctly?
    If not could you provide us with the elf file and your jdebug file?

    Best regards,
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support contact us per e-mail.
    The following contact form can be used for this: Contact Us