J-Flash ARM 3.78c command line problem

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • J-Flash ARM 3.78c command line problem

    Hello:

    I am currently using J-Flash Arm 3.78c through the command line and having trouble piping the output to a file using the “>” command. the US support did experience the same problem where the file gets created without any output. My command that I used is as Follow:

    JFlashARM.exe -openprjC:\Projects\AmigoUTForMainBoardTester\bin\Debug\AT91FR40162.jflash -openBootstrap_Loader.hex -auto > log.log

    any help will be greatly appreciated!!

    Thanks

  • You may want to try something similar to the following. If I run the following batch file everything works as expected.

    @ECHO OFF

    JFlashARM.exe -openprjC:\Projects\AmigoUTForMainBoardTester\bin\Debug\AT91FR40162.jflash -openBootstrap_Loader.hex -auto -exit

    ECHO ERRORLEVEL: %ERRORLEVEL%

    ECHO %ERRORLEVEL% > log.log

    IF ERRORLEVEL 1 GOTO ERROR
    ECHO SUCCESS!
    GOTO END

    :ERROR
    ECHO ERROR!

    :END

    If I run with cable or power disconnected the output is:

    C:\test>test.bat
    ERRORLEVEL: 1
    ERROR!

    If everything is connected as it should be, I get the following:

    C:\test>test.bat
    ERRORLEVEL: 0
    SUCCESS!

    I hope this helps.

    The post was edited 1 time, last by SEGGER - Shane Titus ().