V250 no longer works

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • V250 no longer works

    I have been using V242 under Linux (Centos 7). I just tried running V250 and it fails to run.

    Could not open J-Link shared library. Exiting now.

    Did the current version add a check for the J-Link library? I am running oneshot capture to memory with manual download on ARM7.

    Is this an oversight or deliberate? I don't have or need the J-Link library for my target.

    The post was edited 1 time, last by krbvroc1 ().

  • Hello,

    Thank you for the report.

    You are right, SystemView V2.50 currently needs the J-Link library to check for SystemView PRO licenses on connected J-Links.

    Since it should not be required to have the J-Link software installed, we will add a check for library presence before the license check.
    So with the upcoming version you should be able to use SystemView again without the J-Link Software.

    Best regards