Hello,
I believe that with SystemViewer I should be able to connect to a running target at any time, but at the moment I am not able to do so unless I have an active debug session going. When a debug session is runnig SystemView appears to work as it should, if not I always get an error message "Failed to start recording. RTT Control Block not found".
The device I am working with is a TI Stellaris LM3S2D93, I am using Code Composer Studio V6.2. I am using the gcc toolchain, not TI's toolchain.
Any ideas?
Thanks in advance,
Rene
I believe that with SystemViewer I should be able to connect to a running target at any time, but at the moment I am not able to do so unless I have an active debug session going. When a debug session is runnig SystemView appears to work as it should, if not I always get an error message "Failed to start recording. RTT Control Block not found".
The device I am working with is a TI Stellaris LM3S2D93, I am using Code Composer Studio V6.2. I am using the gcc toolchain, not TI's toolchain.
Any ideas?
Thanks in advance,
Rene