Systemview with debugger

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Systemview with debugger

    Hello support,
    I am using Systemview240a and stand alone it works. But in documentation is written that it should work also parallel with debugger. My configuration is winIDEA debugger with ULTARA+ jlink, speed configured to 50000kHz. What settings in debugger I should make to make it work. Please let me know what is the correct sequence since when Systemview connect to target it resets. I would like to capture recording between two breakpoints.
    thank you
    rum
  • Hello,

    What target device are you using?
    For some devices it is necessary to reset the target to be able to connect to it.
    Since you are running in parallel to the debugger, you could try to select your core in SystemView instead of the device.

    Best regards
    Johannes
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.