embosview not working

singhsi · Jul 11th 2016, 10:32am

I am trying to connect embosview using J-Link via USB interface. But I am not able to see any data on GUI although I am seeing the packets exchange in embosview GUI
(As attached).

Can you please help me to setup the embosview with my target device.

Following are my configurations:
J-Link Version 4.4

target Device :

ATMEL - AT91SAM9CN12

Data Sheet : atmel.com/Images/atmel-11063-3…11-sam9cn12_datasheet.pdf

SEGGER - Til · Jul 11th 2016, 10:57am

HI,

could you please give some basic information?
1. Which embOS and which embOS version are you using?
2. Are you using an embOS start project? Which one?
3. Please ensure in the General Tab "Do not communicate" is not checked

Could you also please check in the according RTOSInit.c if any data is received (_DCC_OnRx())?

Best regards,
Til

singhsi · Jul 11th 2016, 12:17pm

Hi Til,

Thanks for your support. It is working now.

Actually in RTOSinit file , support of DCC was disabled.

#define OS_VIEW_USE_UART 1

#define OS_USE_DCC 0

After enabling the DCC , I am able to see all the relevant information in emboSview GUI.

Regards,
Shobhit

SEGGER - Til · Jul 11th 2016, 1:18pm

Hi Shobhit,

thanks for your feedback.
As long as you are in embOS support you can also contact us directly by the embOS support email address.

Best regards,
Til

Share