[Segger Ozone]GDB commands

  • Hello,

    No, Ozone does not use GDB, but has its own commands.
    In general everything which can be done with GDB can be done with Ozone, too.

    Have a look at the Ozone User Manual for a list of available commands.

    Best regards
    Johannes
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Thanks for the reply.
    I already had a look to Ozone User Manual but did not find what I wanted.

    1) I'm indeed trying to find an equivalent of "GDB waithalt(time)" for Ozone which would wait for a given amount of time during execution before doing a Debug.Halt().
    I can't use Util.Sleep() because I don't want to pause the current operation but just to have a "halt" after the timeout has expired.
    Do you know if it is feasible with Ozone own commands?

    2) I need to call a batch file. In GDB, I would use "shell program_name...". Is it possible to call an external batch file from Ozone?
    3) And I would need also an equivalent to "restore filename [binary] bias start end".
    Indeed, I need to take parts of a binary file, not starting at address 0 and not finishing at the end of the file. Target.LoadMemory() just allows to specify the destination address but not the content area taken into the binary file.
    Thanks for your precious help!

    The post was edited 3 times, last by SamDev ().