Hello All,
i am currently evaluating SystemView and found something strange.
I am using J-Link Pro and the device is a STM32F071CB.
When I have an active debug session via Ozone, then "Target | Start Recording" in SystemViewer 2.34 does not enable the button "Existing session", instead it is greyed out. Connection to J-Link is via TCP/IP.
As far as I read in the SystemView documentation, using an existing Debug session should be possible.
Am I mising something?
Edit:
I found another issue: The time scale is wrong (at least for the ISRs). The period of the SysTick is in reality 1ms, nut is shown in SystemViewer witth 1m29s (in words, 1minute 29seconds)!
The duration of the SysTick ISR is also to high. It is shown as 1.0172ms, while it really is only a few microseconds.
Best regards,
Martin
i am currently evaluating SystemView and found something strange.
I am using J-Link Pro and the device is a STM32F071CB.
When I have an active debug session via Ozone, then "Target | Start Recording" in SystemViewer 2.34 does not enable the button "Existing session", instead it is greyed out. Connection to J-Link is via TCP/IP.
As far as I read in the SystemView documentation, using an existing Debug session should be possible.
Am I mising something?
Edit:
I found another issue: The time scale is wrong (at least for the ISRs). The period of the SysTick is in reality 1ms, nut is shown in SystemViewer witth 1m29s (in words, 1minute 29seconds)!
The duration of the SysTick ISR is also to high. It is shown as 1.0172ms, while it really is only a few microseconds.
Best regards,
Martin
The post was edited 1 time, last by enz ().