Debug Applikation with Power loss

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Debug Applikation with Power loss

    Hello,

    is it possible to debug a target applikation where the power supply is completely shut down? Normaly the debug connection is lost when the target is powered down (jlink lite). With a ulink2 and uvision a massage appears and the debugger waits for the target (LPC1768). Is this also possible with a jlink?

    bye
  • So!!!

    It is possible but the target has to setup set debug interface by its own. I successfully configured the target to output swo-data (printf, pc and irq trace) after powering again.
    Is there a smal tool to analyse the pc/irq output like the swo-viewer?