[SOLVED] RTT on Mac OS X

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] RTT on Mac OS X

    Hi!

    I tried to put this [SOLVED] JLinkRTTLogger for linux
    and this devzone.nordicsemi.com/question/44790/rtt-on-os-x/ together

    I can see the RTT output from the SES, it works every time I start the debugging session.
    Also it works so that I start the debugging session, open JLinkRTTClient on the command line, hit run and then I can see the output on the command line.

    But I cannot see anything when I trigger the

    Source Code

    1. JLinkExe -device nRF51422 -speed 4000 -if SWD

    on the command line.

    Therefore is my question, what are the settings that the SES triggers at the background which makes IDE to be able to make the RTT session work ?

    Thanks!

  • Hi,

    With a current version of the J-Link Software you will have to enter "connect" in JLinkExe to connect to the target.
    When JLinkExe is connected to your target you can start the RTT Client and should see your RTT output.

    Best regards
    Johannes
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.