[SOLVED] target connection problem with Jlink Pro in DS-5 (5.23.1)

  • [SOLVED] target connection problem with Jlink Pro in DS-5 (5.23.1)

    I'm working on a new board with Xilinx xc7z020. Working enviroment is Jlink PRO and ARM DS-5(V5.23.1).The first step is to connect to the target.When connected from Jlink configuration command line, it is Ok .But in DS-5, afte replaced the Dll and setup the ds-5 debug configuration following the instructions in Jlink manual and ds-5 user's guide, the jlink Pro can't be connected althoug jlink pro can be selected from the hardware list in DS-5(detected automatically).Can you give any suggestion to override this problem??
    best regards
    Files

    The post was edited 4 times, last by happyge2me ().

  • Hi,

    we will take a look at it.
    The latest tested DS-5 version is DS-5 5.22 x86/x64, maybe ARM changed the RDDI API again.

    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hi,

    it is mandatory to add the device name to the connection string (e.g. JLinkUSB:174200001:Device STM32F103ZG) in order to use DS-5 with J-Link.
    I just tested DS-5 2.31 x64 and it works fine.

    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.