[SOLVED] J-Link for Raspberry Pi 2

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-Link for Raspberry Pi 2

    I trie to connect my RPI2 with the J-link but without success.

    The RPI2's chip is a 900 MHz quad-core ARM Cortex A7 (ARMv7 instruction set)(Broadcom BCM2836).

    Is it possible to connect to them by the J-Link? And when yes what settings i need to connect?

  • Hi,


    the Debug-Interface of Raspberry PI is disabled per default. You need to manually activate it:
    sysprogs.com/VisualKernel/tutorials/raspberry/jtagsetup/
    I assume this will be the same for Raspberry PI 2. You will need to enable the debugging manually.
    Cortex-A7 is supported by J-Link.
    We did not try to debug a Raspberry PI 2 yet, therefore I cannot provide you with step-by-step instructions.


    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.