Hello.
Just purchased a new J-Link Base 9.3 and upon first use was prompted to update firmware. After firmware update, the J-Link is not recognized by the computer. I have checked in Windows device manager and there is no J-Link device listed. Our company has several other J-Link units and they work fine. Have tried this unit on two different computers with same results. J-Link Configuration tool also does not work (because of no USB connection I would assume).
Purchased the new J-Link Base 9.3 through Digi-key so it should be a legitimate "Real" unit.
The activity LED upon first power is solid for about a second and then enters a rapid flash of approximately 10x a second. No target device is connected to the JTAG port.
We have some other J-Link units in our office and are being prompted to update but are hesitant to do so.
Any thoughts.
Thanks
Dan
Just purchased a new J-Link Base 9.3 and upon first use was prompted to update firmware. After firmware update, the J-Link is not recognized by the computer. I have checked in Windows device manager and there is no J-Link device listed. Our company has several other J-Link units and they work fine. Have tried this unit on two different computers with same results. J-Link Configuration tool also does not work (because of no USB connection I would assume).
Purchased the new J-Link Base 9.3 through Digi-key so it should be a legitimate "Real" unit.
The activity LED upon first power is solid for about a second and then enters a rapid flash of approximately 10x a second. No target device is connected to the JTAG port.
We have some other J-Link units in our office and are being prompted to update but are hesitant to do so.
Any thoughts.
Thanks
Dan