"Program Once Command" for flashing IFR Map

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • "Program Once Command" for flashing IFR Map

    Hi, I would like to Program a serial number into the program Flash IFR och a MK10DX128 CPU.

    According to the manual (K10P32M50SF0RM.pdf) this is done using a command called "Program Once Command". Is it possible to do this with the flasher program (JFlash.exe) ?

    BR, Olof

  • Hi,

    Yes, this is possible. You can add the sequence, described in the chip user manual, into the "Init / Exit steps" in the J-Flash project settings. Theses steps are executed before (init steps) or after (exit steps) programming. For further information regarding this, please refer to chapter Settings -> Project Settings -> Flash settings in the J-Flash user guide (UM08003).

    Best regards
    Erik
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.