JTAG on pandaboard es

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • JTAG on pandaboard es

    Hi,

    I have some problems with the JTAG on pandaboard. I used linux and I have downloaded the tools of your website. When I run JLinkGDBServer I obtain :

    Source Code

    1. SEGGER J-Link GDB Server V4.50i
    2. JLinkARM.dll V4.50i (DLL compiled Jun 22 2012 19:00:36)
    3. The server has been started with the following settings:---Server related settings---GDBInit file: noneListening port: 2331SWO thread listening port: 2332Accept remote connection: yesLogfile: offVerify download: offInit regs on start: onSilent mode: offSingle run mode: off---J-Link related settings---J-Link script: noneTarget interface: JTAGHost interface: USBTarget endian: littleTarget interface speed: 5kHz
    4. Waiting for J-Link connection...J-Link is connected.Firmware: J-Link ARM V8 compiled Jun 19 2012 11:29:30Hardware: V8.00S/N: 58000445Checking target voltage...Listening on TCP/IP port 2331Connecting to target...ERROR: Could not connect to target.Restoring target state and closing J-Link connection...



    and it is in loop. I have tested the jtag on another board with cortex m3 and it works!
    Why with the OMAP 4460 it not works?

    Thanks and best regards,

    Denis