Hello,
I tried to use the "Enable target power" in J-Flash (enabled the checkbox in "Project settings/Production") but the power on Pin 19 of the
J-Link is not enabled. (I checked with a scope). However, if I use "power on" in J-Link commander, the power on Pin 19 is enabled.
Is this a bug in J-Flash or did I make a wrong assumption about the function of this checkbox.
(I am using J-Link software 4.56)
I tried to use the "Enable target power" in J-Flash (enabled the checkbox in "Project settings/Production") but the power on Pin 19 of the
J-Link is not enabled. (I checked with a scope). However, if I use "power on" in J-Link commander, the power on Pin 19 is enabled.
Is this a bug in J-Flash or did I make a wrong assumption about the function of this checkbox.
(I am using J-Link software 4.56)