J-TRACE : No trace clock

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • J-TRACE : No trace clock

    I used J-trace in a lpc2210 board and enabled etm, in IAR environment it always show:
    "Could not start trace: No trace clock
    Please make sure that the trace port of the chip has set up properly."

    ;---------------------------------
    I found the problem, the 38-pin mictor receptacle in lpc2210 board is not welded well:(

    The post was edited 2 times, last by cok ().

  • Thanks for posting the reason!
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.