Search Results

Search results 1-1 of 1.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hi, i got a hardware problem with flashing my board with a Kinetis K22 and the EZP_CS pin. I figured out that the problem is that EZ_Port is enabled due to the pin EZP_CS_not low level at boot up. The level is set by an external IC because i wanted to use the pin as a input pin. My question now is if there is any way to disable the EZ_Port with the Segger J-Link while the pin level enables EZ_Port mode? Maybe by writing the FOPT with another technique, early write, workaround, whatever? And addi…