Search Results

Search results 1-3 of 3.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Updating GUI_App.c not working

    sagerchr - - emWin related

    Post

    Hey, i tried without calling the GUI_Init() mulltiple times. I didn´t helped. Just to make sure that no hardware configuration problems are present i can tell that i followed these steps to create the source code. community.st.com/s/article/FAQ…-using-CubeMX-and-STemWin I have no clue what is wrong in my application, because theoreticcly it should work fine. Do you have any other idea, hint or suggestion? I´m thankfull for every kind of help. Thank you very mutch in advance...

  • Updating GUI_App.c not working

    sagerchr - - emWin related

    Post

    Hej, yes it is running the loop. When i probe "i" it is counting up. I also toggle now an LED on the bord and i see that the code is executed in the speed i want it to. So from that perspective i would say that timing in this case is OK. Is there something else which could be wrongly configured? I realise also, that it seems to just work for a few 50-55 ms. I made two examples which showcase the behaiviour. If the GUI_Delay > 50 - 55 ms then it stops working. The second itteration of the while L…

  • Updating GUI_App.c not working

    sagerchr - - emWin related

    Post

    Hej, i´m running stm32f469i-Discovery Board with CubeMX generated code in SW4STM32. When i run the source code below i will just get something like when i execute the code below: ---------------------------------- |Hello world |0000 | | --------------------------------- I don´t see an upcounting number. Furthermore it seems like the GUI is not constantly updating which to my understanding should be done via GUI_Delay(). - What am i missing? - Is there something in the settings wrong? - How is th…