Search Results

Search results 1-6 of 6.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Now I am able to connect with J-Link Commander. but GDB Server was failed to connect. Could you please let me know what is the issue here? SEGGER J-Link GDB Server V7.92c GUI Version JLinkARM.dll V7.92c (DLL compiled Aug 30 2023 14:58:23) -----GDB Server start settings----- GDBInit file: none GDB Server Listening port: 2331 SWO raw output listening port: 2332 Terminal I/O port: 2333 Accept remote connection: localhost only Generate logfile: off Verify download: off Init regs on start: off Silent…

  • I am trying to install package for NXP MCIMX6D7 which are NXP i.MX6 CPU But I was unable to find the packages from Package Manager. Please let me know how to locate the package for the i.MX6 CPU

  • Thank you for the support we were able to solve the issue. Let's close this thread. Solution: JTAG_MOD needed to be connected to ground, and J-Link 10pin needed the reset (pin10) disconnected.

  • I checked with a brand new board without any firmware (no eFuses set), but I am still getting same result. JTAG_MOD is not set high. Connecting to target via JTAG TotalIRLen = 5, IRPrint = 0x01 JTAG chain detection found 1 devices: #0 Id: 0x2191E01D, IRLen: 05, Unknown device Connect failed. Resetting via Reset pin and trying again. TotalIRLen = 5, IRPrint = 0x01 JTAG chain detection found 1 devices: #0 Id: 0x2191E01D, IRLen: 05, Unknown device

  • Thank you for the response. It looks like I can try the second option first. Do you have a procedure to change IRLen value by changing boundary scan mode to some other mode? I found the procedure to change to the boundary scan mode with Lauterbach JTAG debugger: Do you have something similar for Segger J-Link? Please let me know. Thank you.

  • When I tried to connect our custom board with chipset MCIMX6D7CZK08AD, I am getting the following error. Hardware List: MCIMX6D7CZK08AD board with 10pin TAG CONNECT pattern Segger 10-Pin Needle Adapter Segger J-Link PLUS Compact We have verified that the pin connections on the hardware seem correct. I also attached the log which was capture by JLink Control Panel. Could you please take a look and let me know how to fix the issue? TD764 009:494.940 JLINK_Connect() TD764 009:497.689 TotalIRLen = ?…