Hello jking, I think I have exactly the same illness like yours. I am exactly using the imxrt1170evk revC with a very new JTRACE-PRO over JTAG/ETM interface. it is not a supprise you couldn't have the trace communication if you dont know the 4-bit rise timing setting must be "-0.5ns" (never with default value) with the measure, you may have the trace comminication if you are "lucky" sometimes. I have already created a ticke to complain the issue. 1) the trace commnication with the imxrt1170evk i…
Hello, unfortunately after hard discussion with NXP staff, it was confirmed, the so called "XML" file which works fine with NXP MCUXpressor IDE, is NOT SUITABLE for Segger Ozone. I have already created a ticket for further help from Segger side, if you have convert the XML file from NXP to a suitable SVD file which we can import it to the Ozone.
Hello, I am using the Ozone to debug with a very new JTRACE PRO. Unfortunately I couldn't find any peripheral registers information like ADC/SPI/GPIO etc. (See fig. below) What I expected is like the NXP MCUXpressor IDE offered: (see attachment) Since I am not a fan to debug the code in MCUXpressor (flash process too slow), I really want to stay in Ozone. But how can I setup the peripheral registers in Ozone for specific MCU?