Search Results

Search results 1-2 of 2.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hello, I am evaluating segger embedded studio ide. i wrote a code for stm32 board and try to simulate it . but the peripheral registers are not getting affected. it is constantly showing 0xcdcdcdcd . why is that ? I have not connected any hardware and using simulator mode thank you .

  • Hi , I am working on freertos and systemview in post mortem mode snapshot mode works fine and i had no issues with that. but when i tried post portem mode the events are not collected properly, the trace does not show the freertos task running. Perhaps i may be making mistake while reading the buffer. Please check the attached image. Buffer size = 8192 wroff = 4972 rdoff = 4971 ( so i understood that buffer is full ) according to the user manual , i am first reading from pbuffer+wroff to end of …