Search Results

Search results 1-1 of 1.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • I have searched the forum but I couldn't find any issue about Psoc63 for this problem. I will use SWD pins as GPIOs. When I set it, I am able to program my device for first time. But, it is not possible to program again after first programming. I need to delete firmware of device with psoc programmer by using miniprog then I can program the device again with J-Link. I added a screenshot of commander when I try to program. I have found similar issue as below and its solution depends on software u…