Search Results

Search results 1-2 of 2.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • The solution for anyone struggling with a similar issue was to use the JScript flash erase tool that is installed along with the enablement package. Once the memory was erased, IAR would happily run my application.

  • I'm trying to connect to an Analog Devices ADSP-CM408F board using the included J-LINK lite and IAR EWARM v7.6. When I try to connect, I receive an error:…ac07d9666b18a2be5ecc41f9d As far as I can tell, I've set the project up according to the board manual, and I've installed the enablement package for the board (as per…-ADSP-CM408F-EZ-KIT-Lite/). Connecting through J-LINK commander does not work either; a log file is attached. Thanks…