Search Results
Search results 1-7 of 7.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Hi Nino, Thanks for your reply. Please can you share it with Rolf and Paul. Best regards, Res
-
Hi, Are you planning to supply any additional board support packages for SiFive boards such as the HiFive1 Rev B development kit? If this is planned for some time in the future could you give some links as to how to create a new RISC-V BSP from scratch? Many thanks, Res
-
Hi, When are you planning to add support for the GD32F330 and GD32F350 Cortex-M4 MCU's to the J-Link DLL? Thanks.
-
Hello again Nino, Out of curiosity, I removed V6.34f and installed the beta of V6.35c. It updates the firmware on the J-Link Edu Mini to September 7, 2018. Everything works in J-Link commander now and I see the dialog box about the RXN bit. The only remaining issue is to fix the Chip Erase All (CE2) error in Atmel Studio 7 when using the J-Link Edu Mini as the SWD programmer (see attached screenshot). forum.segger.com/index.php/Att…50f3a892e9f15753635c692a4 Best regards, Resarf
-
Hello Nino, I removed the old DLL and installed V6.34f. I still observe the same issue. I also tried my Segger J-Link Mini Edu on a SAML11 Xplained Pro board and observe the same issue on it too. The only reason I can think of why the issue is not known to SEGGER is that you have never encountered an L11 that has RXN=1 at the start which is how they are supplied from the factory. As you will know, the commands on your L11 wiki page: J-Link>w4 0x4100501C 0x804000 Writing 00804000 -> 4100501C J-Li…
-
I did some more research on this issue. This time I used the J-Link Mini Edu on a SAML10E15A device (this is the part without the Trustzone security features) and ran the same procedure to clear the RXN bit: J-Link>connect Device "ATSAML10E15A" selected. Connecting to target via SWD InitTarget() Found SW-DP with ID 0x0BF11477 Scanning AP map to find all available APs AP[1]: Stopped AP scan as end of AP map has been reached AP[0]: AHB-AP (IDR: 0x04770025) Iterating through AP map to find AHB-AP t…
-
I have soldered a SAML11D15A to an SSOP breakout board and am trying to get some simple Atmel Studio 7 Example code to run on it. I am using a J-Link Edu Mini with the latest firmware and the J-Link DLL is V6.34c. I have followed the instructions on the Segger wiki to attempt to clear the RXN bit in the User Row to enable RAM execution of the re-flashing algorithm but this does not appear to work. The J-Link can initially see a fresh SAML11D15A part running running from the internal 4MHz oscilla…