Search Results
Search results 1-6 of 6.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Hi, thank you for your prompt answer, but when I read the user's manual of RX210group "r01uh0037ej0150_rx210.pdf", the sector from @xff7fc000 to @xff7fffff, which is the user boot area (On chip ROM), is programmable. I must program this area. Is the flasher arm able to do that by the FINE bus? best regards.
-
Hi, I bought a flasher Arm programmer to upload two srecord files. One of these files contains data from 0xFF7FC000 to 0xFF7FFFF addresses. And, this range of addresses is not reachable from jflash software. Could you update your software to fixe this issue or should I use a Renesas emulator? For your information, I will use the FINE bus. best regards,
-
Hi, I have the same problem: first select 2K for the "use target ram" option but there is a problem with EEPROM sector. If you don't need it, it will work(erase sectors/program/verify) best regards, serge
-
Hi, as regards the issue to erase/write the eeprom sector with a flasher arm and jflash.exe(version 610a), when do you think you will able to provide a fixed version of the J-Link software. I tried the last version 610a, and the bug is not fixed. best regards
-
Hi, good news. Thanks Serge
-
Hi, I write a STM32L051 with option bytes without any problem (except rewriting). The STM32L051 is now replaced by a STM32L011K4, I select the ‘’STM32L011K4 with Opt bytes’’ project in the 600i version of jflash. I select the 2K ram size and I have an issue with the @80000 sector (I think it’s the sector corresponding to the EEPROM of the STM32L011K4). You'll find below the error messages. If the sector(@80000) is unselected, it works, but I need it of course. It seems that the writing of the EE…