Search Results

Search results 1-4 of 4.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED]Can Flasher STM8 program Option Byte in ICP mode?

    sompop - - General

    Post

    If possible, I need to program the STM8 Option Byte without IAP code.So, Can Flasher STM8 program the Option Byte in ICP mode? If yes, how to do that? Thanks.

  • [SOLVED]Flasher STM8 not work on STM8S103K3

    sompop - - General

    Post

    Hello, All I found my problem. On my STM8S103 board, the Capacitor at NRST pin is 2.2uF ( Recommend by ST Field Application Engineer ) which is work with ST-LINK. Now, when I replace it with 100nF, evevy thing is OK. Thank you All

  • [SOLVED]Flasher STM8 not work on STM8S103K3

    sompop - - General

    Post

    Thank you, Oliver I try both V1.05 and V1.06b, the result is not defferent. Q: When using the STM8 Commander, does it report that a target chip has been found "Found STM8 (xMHz)" ? A: I think this is a problem, when connect to STM8S103K3, STM8 Commander don't have "Found STM8" message. While connect to STM8S208MB, STM8 Commander show "Found STM8 (8MHz)"

  • [SOLVED]Flasher STM8 not work on STM8S103K3

    sompop - - General

    Post

    Hello I want to use Flasher STM8 as a standalone programer for STM8S103K3 but there have a problem that when I select Unsecure chip, the error message show - ERROR: Failed to unlock chip (MASS unlocking failed) - ERROR: Failed to unsecure chip (removing read out protection failed) - ERROR: Failed to unsecure chip Erase chip, the error message show - ERROR: Failed to check sector status for sector erase - ERROR: Failed to erase chip Program, the error message show - ERROR: Failed to unlock chip (…