Search Results
Search results 1-7 of 7.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
bad code
PostIt seems that you loaded a bad code in your boards. So to recover them you need to boot from RAM(if i's possible) then load any working example. With the latest version of EWARM5.20, you don't need to boot from RAM, you need just to setup the Reset type to core and peripherals and it will work fine.
-
SWD
Postcan you check the connection before downloading code: just run the JLink.exe utility.
-
JFLASH
PostHi, Is it possible to disable the readout/write protection of a STM32 device using JFlash.
-
SWD at STM32
PostHi, The Cortex-M3 SWD (Serial Wire Debug) interface is supported when J-Link version 6 or higher is used. Regards,
-
IAR and J-Link
PostHi, Which board are you using? Rgds