Search Results
Search results 1-1 of 1.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
I cannot make the J-link Segger connect to a microcontroller (Vorago) that uses the Cortex-M4. Details about microcontroller’s setup: - The power supplies (3.3 V, 1.5 V, VRef (3.3V), 5V) on the board all read the expected values, after using a volt meter - The J-link was programmed (through J-link commander) with the “power on” command to output 5 V on pin 19. The 5V can be read on the target’s (JTAG/VDD) pin as 5V. - Pin 19 on the J-link was measured with an oscilloscope and it does output a 5V…