Search Results
Search results 1-4 of 4.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Hi all, I just got a new ATE Flasher and ran into beginner's problems: * I cannot connect to NRF52832AAA via SWD - I get the message "Selected interface (SWD) is not supported by the connected probe" It works with STM32F091, but not with NRF52832 * I don't know how I can read the content of MCU registers over TCP/IP - I need to read the content of FICR.DEVICEADDR[0] and FICR.DEVICEADDR[1] registers. This is quite important, I have to collect the BD_ADDR of each programmed device to check its ope…
-
Welcome to all of you, I would like to ask if it is possible to place an order and pay for it by bank transfer. It would be quite difficult for me to pay a large amount with my card, it has a limit well below the amount of the order. I am a registered EU VAT payer, my company is located in Poland. Unfortunately, again I did not receive a reply to my e-mail from the technical support department. Best regards, Krzysztof Zalewski Translated with DeepL.com/Translator
-
Hi, thank you very much for your comprehensive answer. Best regards, bliink
-
Hi all, a few days ago I sent an inquiry via a contact form, but I did not receive an answer. I hope that I will be able to dispel my doubts here. I'm going to buy "Flasher ATE" programmers and write software for flashing on a small production line. ATE has an Ethernet interface and I intend to use it for communication with programmers. Each firmware has a ~350kB fixed code and 32 unique identifier bytes. One flasher is connected to one programming module. I plan to write software that communica…