Search Results

Hi Nino, Thank you for your reply. I'm aware that the Edu model comes without support, so i regret and apologize for my earlier statement. I was so frustrated when i wrote it. Again, apologies. I was able to manipulate the processor's IO registers through the E2 Studio's IDE via the JLink Edu. I saw the output pins change state as i wrote to them. However, i was never able to get a successful upload of my code to the processor and get it running. The IDE's Debugger UI consistently showed that so…

Thanks again. Were you ever able to find any potential solutions mentioned with using JLink with the RX and getting it working? It looks like i'm going to ask for a refund on the JLink Edu. The Renesas E2 Lite is a little cheaper than the Edu. Since i'm a retired engineer, i really don't have the bag loads of cash, like corporations or banks, for better tools. Engineers, turns out, don't get QE in any form... I'm really disappointed at the lack of input (and perhaps, concern) from Segger (and Re…

Thank you for your reply. At least i know that i'm not the only one experiencing this. I have left messages on this Segger website as well as the Renesas website, but so far, i have not heard of any solutions (actually, yours is the first reply i've had). If JLink has no hope of working with Renesas processors, then a full refund should be due. I really have no clue where to look to start finding the problem's cause. Is it on the Segger side (JLink driver, perhaps?) or the GDB server / driver si…

The full message i get in E2 Studio when the mouse pointer hovers over any particular PDR register settings is (eg): Failed to execute MI command: -data-evaluate-expression &(0xFFu) Error message from debugger back end: Attempt to take address of value not located in memory.

I have been trying to modify the debug settings including GDB Server settings in E2 Studio, but i cannot get the emulator to actually upload the firmware to my board. However, i can toggle the IO register bits on the RX630 through the E2 interface. However, using the JLink never actually runs the firmware or so it seems. I keep getting the "Failed to execute MI command" error message. I forgot to mention: Running Windows 7 Ultimate SP1, E2 Studio V7.6.0 and of course, JLink Edu I have been searc…

Hi, I have not found this issue on the forum, so apologies if it has been covered already. I recently bought a JLink EDU and have started using it with Renesas' HEW and E2 Studio. In the case with HEW, the emulator setup only allowed me to select the 56307, 56308, 5630D and 5630E parts, none of which i am using. I searched for any way to update the device selection for the Renesas processors, but i didn't find any. Regarding E2 Studio: i can find the processor i am using, but the JLink emulation…