Search Results

As below, forum.segger.com/index.php/Attachment/4927/

J-Link updated. But same issue continues. forum.segger.com/index.php/Attachment/4920/

When I tried to debug Iar Arm Embedded Workbench with J-Link. The following error has been occured Hence I cannot debugging forum.segger.com/index.php/Attachment/4915/ Iar version; forum.segger.com/index.php/Attachment/4916/ I have a custom board. MCU is MKE04Z128xxx4 J-Link Drive Properties, forum.segger.com/index.php/Attachment/4918/ Also I tried another J-Link. Same problem continues Any help will be appreciated.

Hello, I have STM32F030C8T6TR MCU. Normally, I can program this MCU by St-Link successfully, I decided to try to program the MCU by J-Link in SWD mode. However, whenever I try to program by JLink Command Line (JlinkCommand.jlink), I get this error "can not attach to CPU. Trying connect under reset" in command line interface. I have connected and checked cable connection many times. When I look up in schematic, I have noticed that, reset pin not connected to programmer. It is always active high. …

Hello, I need to obtain hex file from MCU in cypress MCU, i,e opposite command of loadfile. Is it possible to do that process as I describe above. Any help will be appreciated.

Hi, I look into the following link supported JLink devices for ST segger.com/downloads/supported-devices.php However, I could not find the MCU STM32F051x4 as supported device. Therefore, is there a problem by downloading a firmware this device or I would not download the correspondig firmware. Any help will be appreciated. Yours Sincreley, Mehmet ALKAN

Hi, Dear Nino I have appreciated your instant response and help. Thank you very much

Hello, Is it is possible to learn J-Link Serial Number by Command Line Interface. In the other words, return J-Link Serial Number which are connected to PC by usb when entered correspondig terminal command. I need this corresponding terminal command.