Search Results

Quote from SEGGER - Arne: “Hello, did you try using a blank target? This information would be very helpful, since it might have something to do with the application running on the target. Regards, Arne” I tried the blank target. But there was no display in Jscope. I considered it was because the MCU was halted. I tried the same on 5.10m firm and 6.14f firm. it was the same. no display in Jscope. I think it means nothing.

BTW, during the test period, I had tried: Different JLINK: SN:59102233, SN:59103035 Different Laptop environment: win7, win10. Jscope Version: 5.10c,5.10d,5.11d,6.11f Firmware version: 6.14d,6.14f,6.15c They all did not work properly. After downgrade to 5.10m. Every environment was OK. Please check the firmware! ;)

Hello, Thank you for downgrade method. Everything is OK after I downgrade the firmware to 5.10m(Very old, but I have no time to try other). It did not relate with the Jscope version. It only related with the firmware. During the problem solving period, I had tried 6.14d,6.14f,6.15c. They all had the problem. I hope you can find the bugs ASAP because I need the new TSB M47X MCU flash support. Anyway, if you have any question, please contact me freely, I will support you to find the bugs. the atta…

Dear, I had reported that the new 6.14d firmware had some bugs with the work of Jscope. But until now, i did not get any response. I had used Jscope for a long time. It was useful. But since I installed the new version IAR, it upgraded my JLINK from 6.11 to 6.14d, the Jscope cannot use. If use the Jscope(HSS), it showed the data for a short while(1-2 seconds), then it will be dead with Jlink disconnected. I had tried the firmware 6.14f, it has the same problem. I had tied Jscope version 5.10d,5.…

Quote from SEGGER - Arne: “Hello, are you using Jscope 5.10d? If the J-Link disconnects, this is very likely an internal problem within the firmware. I just gave it a try with different v9 models and our emPower board, but all of them are working well. Could you please tell us the serial number of your J-Link? Which hardware are you connecting to?” My serial number is 59102233. I connected to my own hardware with TSB MCU TMPM470(cortex-M4). My current experience was that if I output a float data…

I had used Jscope to tune the system for realtime debug (By HSS) for a long time. Yesterday, I updated the JLINK firmware to version 6.14d. unfortunately, the Jscope cannot work. It always dead after 1-2 seconds. At the same time, the JLINK was disconnected. But if I don't use the Jscope, the jlink was always connected. My version: win7 32bit IDE: IAR 8.11 Jlink: v9 standard, firmware:6.14d Jscope: 5.11d I highly doubted that the firmware had some bugs with Jscope. But I cannot downgrade my jlin…